It is the C11 multifunction board. Main reasons where the isolated analog voltage and the relay to enable me to stop the motor when the job is finished.
Kirk Wallace wrote: > Which CNC4PC board do you have? > > On Mon, 2007-12-24 at 18:51 +0100, Geert De Pecker wrote: >> Kirk, >> >> Problem is that I bought the cnc4pc board with the speed controller in >> mind. The doc said it supported emc, so I guess there must be a way. >> Arturo of cnc4pc is looking into it. >> >> So if I can avoid adding extra hardware, this would be nice. >> >> I agree if you want very fine control, your solution would be the best >> way to go. >> >> >> Geert > > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
