How do you keep the nose cone from marking up the work?

Thanks
John

On 5 Jan 2008 at 7:53, [EMAIL PROTECTED] wrote:

> I'll post some photos of the two I did later today , stay tuned for a
> link . The graphics shown on the link you supplied don't show the nose
> cone required to make it work properly so it may be a little
> misleading as to how it maintains an even depth of cut. The nosecone
> is adjustable  up and down with the cutter sticking through the center
> of it.  The nosecone rides on the workpiece. keeping the cutter at a
> constant depth. 



-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to