John Kasunich wrote:
> Jim Coleman wrote:
>   
>> On Jan 5, 2008 1:20 PM, John Thornton <[EMAIL PROTECTED] 
>> <mailto:[EMAIL PROTECTED]>> wrote:
>>
>>
>>     How do you keep the nose cone from marking up the work?
>>
>>
>> i was wondering the same thing.  at a few k rpm, seems like anything 
>> would leave some nasties, unless the coolant keeps everything lubricated 
>> enough to just slide over it happily?
>>
>>     
>
> Just guessing, cause I don't have one of those machines, but I bet the 
> cone doesn't spin.
>
> Regards,
>
> John Kasunich
>
>
>   
Good guess John, the cone does not spin. You can buy cones in plastic or 
steel. I use a steel one
but I always engrave anodized aluminum which has a real hard finish. I 
used to be worried that
it would scratch considering it is being dragged around in all of the 
chips, but it doesn't. Probably
would if you are cutting soft aluminum though, then you should use a 
plastic cone I guess.

Bill

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to