On Mon, 2008-01-21 at 21:54 -0600, Javid Butler wrote: > Kirk- > > How are you simulating the input in the office? > > Javid > > ----- Original Message ----- > From: "Kirk Wallace" <[EMAIL PROTECTED]> > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > Sent: Monday, January 21, 2008 9:29 PM > Subject: [Emc-users] Serial ADC Shifting > > > >I have the a serial ADC setup and mostly working, but I have a problem > > with the output value being too high. I shift bit 11 through 0 into a
I was kinda hoping no one would ask that. I just hooked up the AXIS Flood button to the bit input of my component. Which would give the component all ones or all zeros, except when the input is changed during a conversion cycle. This shouldn't make too much difference, a bit is a bit is a bit. So when Flood is on, I get an output of 4095, and 0 when off. -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
