Very neat! Nicely done. Mark
At 11:26 PM 3/5/2008, you wrote: >Hello, All, > >CNC is just good fun but sometimes I like to work with things I can't >see, electromagnetics (i.e. antennas). Hope you find the EMC-based >project I've started, the Enhanced Machine Controller-based Antenna >Range (EMCAR), interesting. You can see it at emcar.sourceforge.net. > >I'll be the first to say that I am not a programmer. So, if any of you >software folks have an interest in antenna measurements, I could surely >use your help (you can see this if you look at the code)! But, in any >case, emcar works for my measurement purposes and there's plenty of room >to improve it in the future. > >I've said it before and will say it again, "Thanks for EMC." > >Hope you all have a good day. > >Regards, > >Bob > >------------------------------------------------------------------------- >This SF.net email is sponsored by: Microsoft >Defy all challenges. Microsoft(R) Visual Studio 2008. >http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ >_______________________________________________ >Emc-users mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
