Gentlemen,
Does Synergy's post allow you to specify the end point of the arc
to be exactly on the circle? The distance between the starting point
and the center of the radius AND the distance between the ending point
and the center of the radius must match.
I don't know the numeric precision of the calculations in EMC but
on a Fanuc control I have had to round down by a part of one ten
thousandth of an inch in some of my manual calculations to make the
circle interpolation work.
thanks
Stuart
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
