Stuart Stevenson wrote: > Gentlemen, > The axes are tuned 'XYZAB', the homing is working, the MPG's are > working. I cannot move the W axis with the MPG. > I have three BOURNS ecw1j-b24-ac0024 encoders I am using for feed > over ride, speed over ride and axis jog. I haven't configured the > speed over ride yet. They may not be the most robust encoders but they > were cheap. :) > The latest configuration files are on www.mpm1.com:8080. > Should it be possible to jog the W axis? Is this setup XYZ AB UVW ? That makes the W axis the eighth. If it is XYZ AB W, then it is only the sixth, do you have the number of axes set up for 8 or 6?
Jon ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
