Thank you Ray and Dave, Your information has been very helpful. I will try it again tonight.
Glenn -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ray Henry Sent: Tuesday, May 13, 2008 2:27 PM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] Motenc-Lite I/O question On Tue, 2008-05-13 at 15:48 -0400, John Kasunich wrote: > Glenn Stewart wrote: > > Gentlemen, > > > > I have the Motenc-lite board with the Enc-Dac board and two I/O boards. So > > as I understand it, I should have 32 digital inputs and 16 outputs. But when > > I try to change the "number of physical inputs" parameter to anything above > > 16 or the outputs above 8, I get an error and EMC no longer loads. Have I > > done something wrong? Do I have to define them first? If I change it back to > > 16/8 everything loads fine. > > > > Thanks > > > > Glenn Stewart > > I'm not sure what you mean by the "number of physical inputs" parameter. > I don't have a motenc board and it's been a long time since I worked > on the one at the CNC Workshop. But the relevant documentation is here: > http://www.linuxcnc.org/docview/html//hal_drivers.html#r1_6 and it > doesn't show any parameters at driver load time. > > You say "I get an error and EMC no longer loads". Please post the exact > error message(s). > > (rant) Whenever you are looking for help with some error, please post > the exact text of the error message. If you are running EMC from an > icon, don't. Open a terminal window and start it from the terminal - > you are much more likely to see important troubleshooting messages that > way. Icons are fine _after_ you have everything working the way you > like it. (end rant) > > Once we know exactly what you are doing and what EMC is doing in > response, we can probably help. Hi Glenn I installed my Motinc Lite. It's an older board using pld rev 2.2. I got mine without jumpers on J7 so just fired it up with the motinc configuration. Hal Show (a Scripts menu) shows all of the IO pins -- 0->31 inputs and 0-15 outputs. They are all motenc.0.??? So without any jumpers for card number it seems to be card zero. I also see estop in and watchdog reset pins. Looking at the parameters I see the usual scaling and offsets for DAC and ADC. There are invert paramerers for the 16 output pins. I don't see a "number of physical inputs" parameter at all. I believe those are fixed at 16 in and 8 out for each of the J4 and J5 connectors. HTH Rayh ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
