Hi Aaron Using the axis interface you should see Vel on the display just below the axis position numbers.
Try running your squares and circle program with Feed Override set about 10% and compare the results. You can click and drag the slider or click on the slide widget to the left of the slider. This is not insurmountable. We can help even a newbie woodworker. ;) HTH Rayh On Mon, 2008-05-19 at 14:37 +0000, aaron Moore wrote: > I do not know the answers to these questions. I come at this as a woodworker > with no cnc > experience to speak of. I was hoping to use the stepconfig wizard, but this > only works > occasionally > > Aaron > > > > ----- Original Message ----- > > From: "Anders Wallin" <[EMAIL PROTECTED]> > > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > > Subject: Re: [Emc-users] Micro stepper driver MSD542 / KL-5042 > > Date: Mon, 19 May 2008 16:47:12 +0300 > > > > > > > > > When I try to engrave a series of 3 squares and a circle, the > > > squares get rounded corners and the circle is miss-placed in the > > > pattern. > > > > Do you have reasonable values for acceleration and max speed set in both > > TRAJ and AXIS_N sections of your INI? > > > > Are you using G64 ? If so, what tolerance are you using: G64PX.XX > > > > ------------------------------------------------------------------------- > > This SF.net email is sponsored by: Microsoft > > Defy all challenges. Microsoft(R) Visual Studio 2008. > > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
