On Sat, 2008-05-24 at 08:27 -0700, Jorge Barrera wrote: > Has anybody ever encounter a problem in which a machine goes crazy > when you replace one of your servos with a servo with brake? > In my case I am using sure-servo motors and drives and when I plug in > the 24V to release the brake the other two motors start hunting > around. I've even tried powering the brake with an independent power > supply plugged in to a different circuit in the building and just > connecting the low site causes the same problem. > > I am little perplex by it. I could go into more details, I've review > the documentation and have been reviewing everything for 3 days now. I > am thinking there has to be an obvious step that I am missing. > > Any comments will be greatly appreciated > > Jorge Barrera > MFG.com > some project details: > http://www.mfgx.com/blogs/opensource/2008/05/15/open-source-hardware-the-beginning
The sure-servo manual says that the brake uses 24VDC so there should not be a lot of radiated noise from it. Could you ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
