Use a end mill for roughing unless there is very little to remove. Ball mills don't cut as well. Likewise use a drill to remove most of a hole the final size it with an end mill...
John On 22 Jun 2008 at 11:17, Andrew Ayre wrote: > Suppose I wish to cut a dome at and the edge of the dome I have to cut > 0.5" below the surface of the wood. Do I use a end mill for roughing > then a ball nose for finishing, or just use a ball nose for the entire > job? > > thanks, Andy > > -- > Andy > PGP Key ID: 0xDC1B5864 > > ---------------------------------------------------------------------- > --- Check out the new SourceForge.net Marketplace. It's the best place > to buy or sell services for just about anything Open Source. > http://sourceforge.net/services/buy/index.php > _______________________________________________ Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
