On Wed, 2008-09-03 at 09:17 -0500, Andy Holcomb wrote:
> These are the hal files that I got with the install cd. I went through
> the hal setup gui and changed the pinout on the lpt port and that was
> all I changed in the hal files.
>
> Let see if this one goes out right on the reply-to
Looks like it went to the list only.
Let me back up a bit because I've just come into this.
1 -- You installed from a CD. Was it 6.06 or 8.08?
2 -- You started stepconf wizard from the menu and setup some
parport pins?
3 -- You started EMC2 from the menu?
And you are getting some aberrant behavior from the motors.
If these are the three steps you took to get going, the configuration
you are running from is in your home directory under
emc2/configs/my-mill. If you changed the name during the stepconf
session then it will be under that changed name.
Rayh
-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
