Richard Acosta wrote: > Hello, my name is Richard, and i´have bought a 7i43 board, wich i hope > to use on a home made drilling machine. > > I´m stuck on the first steps, i have connected this board using parallel > port cable, set jumpers according to what manual says, so, now i don't > know what else to do.
Did you set the jumpers as per the hm2_7i43 manpage? It's here: <http://www.linuxcnc.org/docs/2.2/html/man/man9/hm2_7i43.9.html>, or run "man hm2_5i20" in a terminal to see the copy installed on your computer. > I have been reading about upload a firmware, i don't know how to do > this, and where to obtain it. > > I want to use 3 servos and 3 linear encoders. > As i've read this should be my chossen config: > > regmap HostMot2 register map > sv8.pin 8 Axis servo motor configuration pinout > sv8b.bit Bit file for 8 axis servo motor configuration 400K > > So... whath should i do now?, where to put this files?, how to upload > hostmot2 firmware?, how to tell EMC2 than i'm using this board. > > Can anyone send an example?... or an easy to understand step by step > guide?, i know some about linux, but at an user level. As far as I know, there does not yet exist a complete machine configuration file for hostmot2. I believe Eric Johnson is working on one, but for a stepper-based machine. I don't know exactly how to write a configuration for a complete machine yet (my machines exist only in my head so far...). But I think you should be able to inspect the existing machine configs that Kirk Wallace pointed you to, and inspect the partial hostmot2 configs, and synthesize something that'll work. The hostmot2 configs for 2.2 (if you're installing the .debs) are here: <http://cvs.linuxcnc.org/cgi-bin/cvsweb.cgi/emc2/configs/hostmot2/?only_with_tag=v2_2_branch> The hostmot2 configs for the CVS TRUNK (if you're compiling from source) are here: <http://cvs.linuxcnc.org/cgi-bin/cvsweb.cgi/emc2/configs/hostmot2/> The HAL User Manual and the EMC2 Integrator Manual are both valuable resources that describe the systems you'll be working with to create the configuration. They're available here: <http://www.linuxcnc.org/docs/devel/> -- Sebastian Kuzminsky "Much of what we learned from the sense of touch was unscientific prejudice, which must be rejected if we are to have a true picture of the world." -- Bertrand Russell ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
