Arnold, Depending what the rotary table mode will do I think you will need to have a dual drive set up. You will need motor to drive the spindle during spindle mode and a motor to drive the spindle for rotary table mode. You will need to engage one motor or the other depending on the mode. Just my opinion. Stuart
On Thu, Nov 13, 2008 at 3:59 PM, Arnoldo Riter CNC <[EMAIL PROTECTED]> wrote: > Hello Everyone, > > I am working in a cnc conversion for a bf20 mil and 250x500 lathe > > I'll use Delta servos+ 5i20 + 7i33 and 7i37 mesa card > I think to use a 1000wts Delta servo in order to power the > (Spindle)-(Rotary axe) > > *I need to switch the spindle on the fly to be used like a rotary axes > and viceversa > * > Could it be done? > How can I achieve that? It is posible to use and M code to change > configuration of the Spindle-Axe > Any information or clue will be welcome > > Thanks very much > Arnold > > > ------------------------------------------------------------------------- > This SF.Net email is sponsored by the Moblin Your Move Developer's challenge > Build the coolest Linux based applications with Moblin SDK & win great prizes > Grand prize is a trip for two to an Open Source event anywhere in the world > http://moblin-contest.org/redirect.php?banner_id=100&url=/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
