hi i found 1 way about G43. Page 80. Exp. G44 H3 - offset for Tool 3 than - "where the H number is the desired index in the tool table. " where is that "tool table"?
> hello > i went to the wiki, and got the users manual > then i looked in the index > i found 2 ways to use tool length offsets inemc2 > regards > tomp > > [email protected] wrote: >> Hi >> I just finish run program with 86 000 lines. It took 4.5 hours. I finish >> reinforcing frame of my machine and run program generated with VCARVE >> product of Vectric . >> >> I also look for G43 H1 operation and cant can’t find how to input H(n) >> for >> tool length like >> H1… H2….Hn >> How to input tool length offset H1 …. >> Thanks >> Aram >> >> >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
