Would the charge pump be easier and more practical to implement? I know my charge pump card wasn't picky about the actual frequency of the signal, anything at or above the 10Khz is sufficient. I don't know from a workload standpoint if one method over another (Charge pump vs PWM) is less CPU overhead or not. Just tossing the idea out there.
Greg www.distinctperspectives.com > -----Original Message----- > From: Florian Rist [mailto:[email protected]] > Sent: Sunday, February 01, 2009 2:43 PM > To: Jeff Epler; Enhanced Machine Controller EEMC" > Subject: Re: [Emc-users] 10kHz Enable Signal? > > Hi Jeff > > > To get a 10kHz square wave, you need to have BASE_PERIOD 50000 or > > lower. Then simply set up a pwmgen. > > I guessed I need some PWM stuff, but it´s not that simple to get started > with the HAL syntax. > > > Here's a starting point for you. > > Thank you very much. > > cu > Flo > > > > ---------------------------------------------------------------------------- -- > This SF.net email is sponsored by: > SourcForge Community > SourceForge wants to tell your story. > http://p.sf.net/sfu/sf-spreadtheword > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
