robert wrote: > here a peak at my ini file > > http://pastebin.ca/1447603 > > > > > Terry wrote: >> That looks just like my Hurco VMC 20 just a different color >> >> My motors are AC (red caps) so putting on encoders is out,as >> I dont think I can line up the com good enough.Im sure someone >> would do this for me for a fee,but I am too cheap. >> > i dont have too much info on redcaps as all my machines are yellow > caps next models up but im sure i may have something in the stash of > manuals. >> Your tool changer works just like mine.As far as >> spindle orient goes I have a buddy who will program >> a microchip to use the orient command from EMC and >> take over the VFD,when orient is complete the micochip >> will send a signal back to EMC. >> > once i get changer working as it should (only bug i have now is tool > 16 to 1 and reverse but i think i have it sorted now) ill send over my > PLC if you like. ill add it on wiki too > what spindle drive do you have? fanuc or other? > if fanuc and as u say you have a mag sensor on side of spindle why not > use it? as now it goes into drive correct? all you need to do is > inable a pin on VFD and it will go into close loop mode for you and > orient the spindle. > > did you read this wiki page > http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Closed_Loop_Spindle_Speed_Control > > > im sure taken this and tweaking it will give a closed loop spindle as > you say ur VFD takes +-10v signal > then u can index spindle to how u like and need >> I will get some numbers off the servo drives and see >> if you have a manual. >> It is nice to talk to someone about common problems and >> machines. >> I am not sure how to do the irc thing and I would >> only be able to be on 10:00 pm central US time,I dont know >> what time that is for you. >> > just head over to the website use the online version, > http://www.linuxcnc.org/component/option,com_mospjirc/Itemid,8/lang,en/ > im up most of the time :) >> Once again thanks for the help >> >> Terry >> >> > >
------------------------------------------------------------------------------ OpenSolaris 2009.06 is a cutting edge operating system for enterprises looking to deploy the next generation of Solaris that includes the latest innovations from Sun and the OpenSource community. Download a copy and enjoy capabilities such as Networking, Storage and Virtualization. Go to: http://p.sf.net/sfu/opensolaris-get _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
