Good afternoon group.
Well, my project (converting and old Centroid controller over to EMC2) has
hit a very large bump in the road. At least for me it's large. Apparently
the drive cards which I assumed were step and directions drive cards, are
not. They are Chop2 drive cards.
So now, I either put the unit back together and forget about the conversion;
come up with some 4 signal to 3 signal interface, or switch out the drive
cards and find a drive card that will interface with the C10 to the motors.
I have an e-mail out to Centroid to see if these motors are stepper motors
or chop motors. So far what I can find on the internet show that they are
stepper motors.
Thanks,
Martin
------------------------------------------------------------------------------
Join us December 9, 2009 for the Red Hat Virtual Experience,
a free event focused on virtualization and cloud computing.
Attend in-depth sessions from your desk. Your couch. Anywhere.
http://p.sf.net/sfu/redhat-sfdev2dev
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
