looks very nice! On Tue, Feb 15, 2011 at 12:55 PM, Klemen Ozebek <klemen.oze...@gmail.com>wrote:
> Dear all, > > on the link below you can se my first test of scratch built lathe which > runs > by EMC2. Hardware which is used on lathe: CT Unimotor AC servo motors, > Digitax ST AC Drives, Commander SK - for spindle, Mesa 5i20 fpga + 7i33 > analog servo card + 7i42. > > Best regards. > > > > http://www.youtube.com/watch?v=6UagccI5zb4 > > ------------------------------------------------------------------------------ > The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: > Pinpoint memory and threading errors before they happen. > Find and fix more than 250 security defects in the development cycle. > Locate bottlenecks in serial and parallel code that limit performance. > http://p.sf.net/sfu/intel-dev2devfeb > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: Pinpoint memory and threading errors before they happen. Find and fix more than 250 security defects in the development cycle. Locate bottlenecks in serial and parallel code that limit performance. http://p.sf.net/sfu/intel-dev2devfeb _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
