On Tuesday, February 15, 2011 12:55:33 pm Klemen Ozebek wrote: > Dear all, > > on the link below you can se my first test of scratch built lathe which > runs by EMC2. Hardware which is used on lathe: CT Unimotor AC servo > motors, Digitax ST AC Drives, Commander SK - for spindle, Mesa 5i20 > fpga + 7i33 analog servo card + 7i42. > > Best regards. > > > > http://www.youtube.com/watch?v=6UagccI5zb4
Kewl! -- Cheers, Gene. From my laptop in Iron Mountain MI. Proof of my failing memory, the last time I was here in February, I said never again. But here I am, after a 900+ mile drive, 300 of it in a howling blizzard. Since I can't be trusted, I think I'll advertise for a guardian when I get home again... And now on the way home, in Bridgeport MI ATM. ------------------------------------------------------------------------------ The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: Pinpoint memory and threading errors before they happen. Find and fix more than 250 security defects in the development cycle. Locate bottlenecks in serial and parallel code that limit performance. http://p.sf.net/sfu/intel-dev2devfeb _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
