> > I've been known to mount an inexpensive router (Hitachi) on the bottom > of my spindle for routing. > > I use a $24 HF long shaft electric die grinder
> Whatever you do dust is going to be a problem. > The EDG does not blow motor cooling air at the bit point so the dust just piles up around the cutting point. Since the dust exiting the cut is only getting accelerated by the bit, small shop vac mounted within 2 inches of the bit provides enough suction to capture the finest dust. BG > HTH > > Dave > > > > > > > ------------------------------------------------------------------------------ > WhatsUp Gold - Download Free Network Management Software > The most intuitive, comprehensive, and cost-effective network > management toolset available today. Delivers lowest initial > acquisition cost and overall TCO of any competing solution. > http://p.sf.net/sfu/whatsupgold-sd > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ WhatsUp Gold - Download Free Network Management Software The most intuitive, comprehensive, and cost-effective network management toolset available today. Delivers lowest initial acquisition cost and overall TCO of any competing solution. http://p.sf.net/sfu/whatsupgold-sd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
