Sorry about any confusion. I am going to retain the motors. I am planning on upgrading the resolver/ tac gen setup with encoders. I was actually have built some of the UHU HP boards but recent testing has been given poor results @ operating voltages (160v). They showed promise @ 100v but when setup to 160v some of the traces on the boards fried. I would prefer an off the shelf component that is dependable and more reliable for this installation. So I am curious what other peoples suggestions are.
----- Reply message ----- From: "andy pugh" <[email protected]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Subject: [Emc-users] DC Brush servo drives Date: Thu, Aug 18, 2011 6:58 am On 18 August 2011 14:03, [email protected] <[email protected]> wrote: > While I am still a long ways from completing my lathe project I have come to > a crossroads with my drive system. I would like use the existing Fanuc DC > brushed drives. But am having a hard time deciding what I should go with. > They are Fanuc models 10m and 5m. > What drives are people using to drive their Brushed beasts with? I am not sure I understand the question. Is it just the Fanuc motors you intend to retain, or the motor-drives (amps) too? -- atp "Torque wrenches are for the obedience of fools and the guidance of wise men" ------------------------------------------------------------------------------ Get a FREE DOWNLOAD! and learn more about uberSVN rich system, user administration capabilities and model configuration. Take the hassle out of deploying and managing Subversion and the tools developers use with it. http://p.sf.net/sfu/wandisco-d2d-2 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Get a FREE DOWNLOAD! and learn more about uberSVN rich system, user administration capabilities and model configuration. Take the hassle out of deploying and managing Subversion and the tools developers use with it. http://p.sf.net/sfu/wandisco-d2d-2 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
