On 7 September 2011 21:03, Brian May <[email protected]> wrote:
> I am using the GS2 driver to communicate to a automation direct GS3 motor > controller. It seems to be working fine. However, I need to set the > parameter spindle-vfd.nameplate-RPM in a hal configuration file and I keep > getting errors that says the parameter does not exist. Once I load EMC I > can go into the hal configuration and set it there - but for some reason I > cannot set in the HAL file. Any ideas what I am doing wrong? It is likely that the component that creates the pin in question is loaded after the place where you are trying to connect it, either in a HAL file that loads later in the sequence, or in a GUI element. If you put the net command in the postgui.hal file in your config it will work for either situation. -- atp "Torque wrenches are for the obedience of fools and the guidance of wise men" ------------------------------------------------------------------------------ Using storage to extend the benefits of virtualization and iSCSI Virtualization increases hardware utilization and delivers a new level of agility. Learn what those decisions are and how to modernize your storage and backup environments for virtualization. http://www.accelacomm.com/jaw/sfnl/114/51434361/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
