On Wed, 2012-03-14 at 21:56 -0500, Scott Hasse wrote: ... snip > Or are you suggesting not doing analog-to-frequency > but rather something like 8 digital inputs and using the weighted_sum > component? ... snip
Yes, analog to Arduino to parallel port. I didn't realize you already had an Arduino in the loop. I would think you could use ten parallel port and Arduino pins to feed the analog value to LinuxCNC. The "SPP experiment" section here: http://wiki.linuxcnc.org/cgi-bin/wiki.pl?AVR shows a setup for sending eight bits at a time out to an AVR with SPP, input with ten bits shouldn't be too much harder and can run at or close to the base thread rate. -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/index.html California, USA ------------------------------------------------------------------------------ This SF email is sponsosred by: Try Windows Azure free for 90 days Click Here http://p.sf.net/sfu/sfd2d-msazure _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
