On 7/25/2012 5:47 PM, John Stewart wrote: > Me again; > > Ok - top (with key press "1") shows 2 cpus, one idle ALL the time. > > With the LinuxCNC 2.5 "release-version", downloaded about a month ago, The > "taskset" is not getting called as it should be. > > So, LinuxCNC runs on CPU0, along with everything else. > > Now to find out where that taskset should be getting called from. At least I > can turn on ethernet on my linuxcnc computer, because the issue is getting > close to being resolved. > > This stuff should be put in the "Troubleshooting" document - following Kent's > instructions (as great as they are) does not get one to the solution. > > > Thanks; > > John Stewart. > John,
I'm not sure yet what all "this stuff" is, but certainly I intended my contribution to the wiki to be amended as needed. The fact that the realtime kernel runs beyond (or below, if you like) the ken of the Linux kernel and all its useful tools like top and htop must be taken into account. Good luck. Regards, Kent ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
