Perhaps instead of an INI flag the interpreter should simply look at the current G7/G8 mode? Would this do what you're looking for?
Rogge -----Original Message----- From: andy pugh [mailto:bodge...@gmail.com] Sent: Wednesday, November 07, 2012 2:12 PM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] Ideal Tool Table On 7 November 2012 17:32, Jeff Johnson <john...@superiorroll.com> wrote: > I would like to see the wear offsets applied in full also, I agree that it > is less math for the operator. Not knowing how or what is involved on the > LinuxCNC side could that be just a parameter to change for either Full or > half in the INI file? One way of doing this (which is currently available when setting tool offsets with touch-off) would be to always use full diameter (or radius) but allow mathematical expressions in the entry box. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ LogMeIn Central: Instant, anywhere, Remote PC access and management. Stay in control, update software, and manage PCs from one command center Diagnose problems and improve visibility into emerging IT issues Automate, monitor and manage. Do more in less time with Central http://p.sf.net/sfu/logmein12331_d2d _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users