Now you need to set your ini entries for min and max limit and you'll never jog into a limit switch again.
On 11/29/2012 8:30 PM, Scott Hasse wrote: > All- > > I'm running a pncconf-generated configuration with shared home and limit > switches. I find that if I hit a limit switch, even if I check the > "override limits" checkbox in the AXIS GUI I'm unable to jog off the limit > switch (the job remains grayed out). I do notice that the UI seems to > become a bit unresponsive for a second or two after checking the box, and > the box does become checked, but none of the jog options change. > > There are four switches, an X max, X min, Z max and Z min. This is a lathe > configuration. > > Is that expected behavior or something I need to look into further? My > impression was that I should be able to jog only in the direction to get > off the limit. > > The machine configuration is under revision control here: > > http://code.google.com/p/sector67-sandbox/source/browse/#svn%2Ftrunk%2FSiegLathe%2Flinuxcnc%2Fsieg_kc4s > > Thanks, > > Scott > ------------------------------------------------------------------------------ > Keep yourself connected to Go Parallel: > TUNE You got it built. Now make it sing. Tune shows you how. > http://goparallel.sourceforge.net > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Keep yourself connected to Go Parallel: TUNE You got it built. Now make it sing. Tune shows you how. http://goparallel.sourceforge.net _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
