John Thornton wrote: > Now you need to set your ini entries for min and max limit and you'll > never jog into a limit switch again. > One slight quibble, you need to home first before the soft limits can know what the safe travel zone is. Then, you need to set the .ini file parameters MAX_LIMIT and MIN_LIMIT to slightly less than the range of travel that will hit the switches. But, after homing, then John is correct, it becomes impossible to jog or command movement into the limit switches. Good for jogging, but REALLY GREAT for setting up, as you get a "program exceeds <some> axis limit at line 123" error message when you load the G-code file or when you hit the run button, before actually starting any cutting. Then you know you need to reposition the part.
Jon ------------------------------------------------------------------------------ Keep yourself connected to Go Parallel: TUNE You got it built. Now make it sing. Tune shows you how. http://goparallel.sourceforge.net _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
