Jeremy I my experience, if there are balls missing the motion will become sticky at any stage. It depends on the amount of ball that are gone. One or two might still be ok but more will be suspect.
On 2013/08/24 04:33 AM, jeremy youngs wrote: > hello fellas, !! > been a bit but i came back from mo with some surplus center ballscrews i > had hangin around down there. i had to flip the ball nut 180 degrees to > make it work out right , my question is shouldnt the screw be completely > filled with balls? when i reassembled it neither race was completely full , > in fact they were not even visible in the other race at all. I have a spare > screw and could remove some balls from it but i am uncertain if this is > necessary, any input would be appreciated thanx guys > ------------------------------------------------------------------------------ > Introducing Performance Central, a new site from SourceForge and > AppDynamics. Performance Central is your source for news, insights, > analysis and resources for efficient Application Performance Management. > Visit us today! > http://pubads.g.doubleclick.net/gampad/clk?id=48897511&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Regards / Groete Marius D. Liebenberg MasterCut cc Cel: +27 82 698 3251 Tel: +27 12 743 6064 Fax: +27 86 551 8029 Skype: marius_d.liebenberg --- avast! Antivirus: Outbound message clean. Virus Database (VPS): 130823-1, 2013/08/23 Tested on: 2013/08/24 09:31:32 AM avast! - copyright (c) 1988-2013 AVAST Software. http://www.avast.com ------------------------------------------------------------------------------ Introducing Performance Central, a new site from SourceForge and AppDynamics. Performance Central is your source for news, insights, analysis and resources for efficient Application Performance Management. Visit us today! http://pubads.g.doubleclick.net/gampad/clk?id=48897511&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
