hello fellas, !!
been a bit but i came back from mo with some surplus center ballscrews i
had hangin around down there. i had to flip the ball nut 180 degrees to
make it work out right , my question is shouldnt the screw be completely
filled with balls? when i reassembled it neither race was completely full ,
in fact they were not even visible in the other race at all. I have a spare
screw and could remove some balls from it but i am uncertain if this is
necessary, any input would be appreciated thanx guys
------------------------------------------------------------------------------
Introducing Performance Central, a new site from SourceForge and
AppDynamics. Performance Central is your source for news, insights,
analysis and resources for efficient Application Performance Management.
Visit us today!
http://pubads.g.doubleclick.net/gampad/clk?id=48897511&iu=/4140/ostg.clktrk
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
