2013/10/1 Erik Friesen <e...@aercon.net> > Were you using aluminum? What type of draft did you use on the moulds? > > Yes. Usually splitted molds or ejectors in the bottom that could be manually knock the piece out. Another simple trick is to drill a small hole and plug it with a tiny bit of clay at the mold side. Then you can pop the piece out with compressed air.
Draft, depends on the part but with a ejector pin or two and a splitted mold you can go vertical. I recently made a few parts with no draft and molded in epoxy. http://farm8.staticflickr.com/7152/6686837519_9a8b65926b_z.jpg ------------------------------------------------------------------------------ October Webinars: Code for Performance Free Intel webinars can help you accelerate application performance. Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from the latest Intel processors and coprocessors. See abstracts and register > http://pubads.g.doubleclick.net/gampad/clk?id=60134791&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
