I reproduced this issue on a fresh latest stable and updated LinuxCNC installation with config (attached to next post) without additional hardware. I had to install linuxcnc-dev, glade (if I remember correctly), compile all .comp files and xhc... .cc file for USB wireless pendant (make and make install), you can follow these instructions also: http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Using_A_XHC-HB04_Wireless_MPG_Pendant
Then run LinuxCNC, home all axes, open 3D_Chips.ngc and run it. You should see the machine writing "LinuxCNC". BTW, I think I found another or related problem - LinuxCNC freezes for some time (roughly 5-20 seconds) for example, when pressing Shift-Home in axis (touch off). And the time required for the same operation differs abnormally. I spent around 5 hours, trying to find the reason, but I couldn't separate it.. Except for something, related to LinuxCNC CPU load. But the load didn't reach more than 40% when locking occurs. On 2014.01.13 06:33, Chris Radek wrote: > On Sun, Jan 12, 2014 at 06:45:33PM -0800, jrmitchellj . wrote: >> Yes, 2.5.3. >> I duplicated the issue again today. > Can you describe a step-by-step procedure that someone else can > follow, that will show the problem occurring? > ------------------------------------------------------------------------------ CenturyLink Cloud: The Leader in Enterprise Cloud Services. Learn Why More Businesses Are Choosing CenturyLink Cloud For Critical Workloads, Development Environments & Everything In Between. Get a Quote or Start a Free Trial Today. http://pubads.g.doubleclick.net/gampad/clk?id=119420431&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
