On 28 February 2014 15:18, Mark Tucker <[email protected]> wrote:
I have the following in my hal file:- > > # This output is on DB25-14 and is currently tied to spindle control > (M3/M5) > net Output1 bb_gpio.p8.out-13 => halui.spindle.is-on > That's sort-of the wrong pin (it is a userspace tell-tale about spindle state, not the intended command pin). use motion.spindle.is-on instead. (and associated pins) http://www.linuxcnc.org/docs/html/man/man9/motion.9.html -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Flow-based real-time traffic analytics software. Cisco certified tool. Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer Customize your own dashboards, set traffic alerts and generate reports. Network behavioral analysis & security monitoring. All-in-one tool. http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
