and Andy has the better solution... (fixing the button problem and the problem you didn't even know you had.. :) )
sam On 2/28/2014 9:39 AM, andy pugh wrote: > On 28 February 2014 15:18, Mark Tucker <[email protected]> wrote: > > I have the following in my hal file:- >> # This output is on DB25-14 and is currently tied to spindle control >> (M3/M5) >> net Output1 bb_gpio.p8.out-13 => halui.spindle.is-on >> > That's sort-of the wrong pin (it is a userspace tell-tale about spindle > state, not the intended command pin). > use motion.spindle.is-on instead. (and associated pins) > http://www.linuxcnc.org/docs/html/man/man9/motion.9.html > > ------------------------------------------------------------------------------ Flow-based real-time traffic analytics software. Cisco certified tool. Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer Customize your own dashboards, set traffic alerts and generate reports. Network behavioral analysis & security monitoring. All-in-one tool. http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
