Andrew Not knowing what your settings are, I am guessing that you might have the TRAJ settings the same as the AXIS settings for velocity. Something to bear in mind is that the settings in the TRAJ section are units per second whereas the others are units per minute.
On 2014-03-06 20:56, Andrew Back wrote: > Hello, > > I've been experiencing problems with the Z axis stalling on a Denford > Novamill with a SmartStep/3 controller. I can stop this from happening > by reducing the Maximum Velocity setting on the Manual tab in the GUI. > However, I'm confused as to why this would override -- and thus > seemingly render pointless -- the corresponding velocity configuration > in the INI file. > > Also does anyone know where I can find the stepper drive timing > settings for a Baldor SmartStep controller? > > Regards, > > Andrew > -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 ------------------------------------------------------------------------------ Subversion Kills Productivity. Get off Subversion & Make the Move to Perforce. With Perforce, you get hassle-free workflows. Merge that actually works. Faster operations. Version large binaries. Built-in WAN optimization and the freedom to use Git, Perforce or both. Make the move to Perforce. http://pubads.g.doubleclick.net/gampad/clk?id=122218951&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
