I might add the developers and other contributors were very helpful when I asked for help on any subject related to LinuxCNC.
On Thu, Apr 3, 2014 at 2:46 PM, Kirk Wallace <[email protected]>wrote: > On 04/03/2014 12:03 PM, John Alexander Stewart wrote: > > Steve; > > > > I'm still stuck lathe wise though, I may just have to bite the bullet > >> and get a Siemens or Fanuc control otherwise I may well be in the grave > >> before it gets released here or Mach 4 turn materialises. > >> > > > > I thought the new Tormach lathe runs LinuxCNC? Or are the reports out > there > > wrong? > > > There might be a hint here at the bottom of the page: > http://www.tormach.com/lathe_specs.html > > -- > Kirk Wallace > http://www.wallacecompany.com/machine_shop/ > http://www.wallacecompany.com/E45/ > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
