On 2014-08-12 17:08, Sebastian Kuzminsky wrote: > On 8/12/14 9:04 AM, Marius Liebenberg wrote: >> I connected my spindle cmd signal to an abs component. When I set the >> speed for any output positive or negative, I get absolutely no output. >> Nor does any of the polarity indicators function. >> The setup uses a 5i25 with a 7i76 so I had to load EMCMOT with the base >> thread enabled as the abs component takes a float for input and output. >> Any ideas? > Hard to tell without seeing your hal config.
Very straight forward connection in and out. > > Did you addf the abs function to the proper place in the proper thread? > I get an error if I do addf so I left it out. I can see the function in the list of halshow though. Does that mean it is not loaded properly? -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 QQ 1767394877 ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
