Are you using g 2.6? 2.6 has spindle abdolute output, In rpm and rps, iirc
Chris M ----- Reply message ----- From: "Marius Liebenberg" <mar...@mastercut.co.za> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Subject: [Emc-users] No output from abs component Date: Tue, Aug 12, 2014 8:05 AM I connected my spindle cmd signal to an abs component. When I set the speed for any output positive or negative, I get absolutely no output. Nor does any of the polarity indicators function. The setup uses a 5i25 with a 7i76 so I had to load EMCMOT with the base thread enabled as the abs component takes a float for input and output. Any ideas? -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 QQ 1767394877 ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
