It seems to be working the wrong way round. I start with the tool at the X0 Y18 Z0 position then when I execute, The tool lifts up to Z20, goes to the next position, then dives down to Z0 and starts to retract at the feed rate up to Z20 plus something?? This is repeated for all four holes but obviously nothing is drilled. Any ideas here?
On 2014-09-29 17:08, andy pugh wrote: > On 29 September 2014 15:59, Marius Liebenberg <[email protected]> wrote: >> So the code is like this if I am correct >> >> g90 g0 x0 y18 z20 >> g91 g81 ^90 z-5 r20 l4 f100 > Looks right to me, but I would run it without a drill or the chuck > first, I think :-) > > -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 QQ 1767394877 ------------------------------------------------------------------------------ Slashdot TV. Videos for Nerds. Stuff that Matters. http://pubads.g.doubleclick.net/gampad/clk?id=160591471&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
