I still have the vari-speed belt on my BP so I just run the inverter at 1800 hz for every op and dial in the speed. I guess when I get around to putting a timing belt drive on the spindle I'll have to get a bit more fancy. I'm the tool changer (Kwik Switch spindle) so I have to be there to start a program or change a tool so it's no more effort for me.
JT On 1/7/2015 11:41 PM, Mark Johnsen wrote: > Thanks everyone for the feedback. I'll go w/ the standard Hal Gearchange > component. Should be perfect. > > JThornton - I agree w/ you, I probably won't use low much, but good to have > it setup now so I can if I need it. And, at least I understand what is > going on behind the scenes. > > Thanks, > Mark J. > ------------------------------------------------------------------------------ > Dive into the World of Parallel Programming! The Go Parallel Website, > sponsored by Intel and developed in partnership with Slashdot Media, is your > hub for all things parallel software development, from weekly thought > leadership blogs to news, videos, case studies, tutorials and more. Take a > look and join the conversation now. http://goparallel.sourceforge.net > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Dive into the World of Parallel Programming! The Go Parallel Website, sponsored by Intel and developed in partnership with Slashdot Media, is your hub for all things parallel software development, from weekly thought leadership blogs to news, videos, case studies, tutorials and more. Take a look and join the conversation now. http://goparallel.sourceforge.net _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
