> On 17 Jan 2015, at 22:06, Kirk Wallace <kwall...@wallacecompany.com> wrote:
>
> I think you will get a following error when an axis is moved.
In that case you would also need a mux2 controlled by the same signal to switch
the feedback between encoder position and commanded position for each axis.
Though that would lose the DRO so perhaps it would be better to change the
F-error limits.
It might actually be easier to start a completely separate config for manual
use with NO_FORCE_HOMING, wide error limits and no servo activation.
------------------------------------------------------------------------------
New Year. New Location. New Benefits. New Data Center in Ashburn, VA.
GigeNET is offering a free month of service with a new server in Ashburn.
Choose from 2 high performing configs, both with 100TB of bandwidth.
Higher redundancy.Lower latency.Increased capacity.Completely compliant.
http://p.sf.net/sfu/gigenet
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
