> From: tom-...@bgp.nu
> Date: Fri, 17 Apr 2015 11:07:00 -0400
> To: emc-users@lists.sourceforge.net
> Subject: Re: [Emc-users] Pncconf with 6i25 and 7i85s in 2.7-pre6
>
>
> > On Apr 16, 2015, at 8:45 PM, Chris Morley <chrisinnana...@hotmail.com>
> > wrote:
> >
> > The 7I85s is a 4 axis stepgen + encoder interface. Does pncconf know how to
> > make closed loop stepgen + encoder feedback configurations?
> >
> > Yes - if you pick an x axis stepper and x axis encoder (but not an x axis
> > analog) then pncconf will do a closed loop stepper config.
> >
> > I haven't check this in a long time so it might need some tweaks.
> >
> > Firmware XMLs must be put in /lib/firmware/hm2/BOARDNAME for pncconf
> > to notice them.
>
> I created a directory /lib/firmware/hm2/5i25 and put the 7i85sx2.xml and
> 7i85sx2.bit files there. PNCCONF now sees the 5i25 and 7i85s. I also have a
> 7i84 connected via serial to the 7i85s, that it doesn’t see. Do I also need
> to add a 7i84.xml file for that to work? Not sure where to find that, it
> doesn’t seem to be in the config files I downloaded for the 5i25 card.
>
> > By 2.8 pncconf will read the info from a live system YAAY!
>
> That would be nice!
> -Tom
>
I down loaded 5i25_7i85_x2.xml from mesa and added to pncconf.
on the connector 2 tab I could select the 7i84 on the second combo box down on
the left.
i should be able to select the same thing on the other tab but cannot - I'll
look into it.
Is this not the same for you?
Chris M
------------------------------------------------------------------------------
BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT
Develop your own process in accordance with the BPMN 2 standard
Learn Process modeling best practices with Bonita BPM through live exercises
http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_
source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
