While mentioning the top speed no one is mentioning the acceleration
rate, try slowing that down. Also increase supply voltage to the
motor/drive as this also gives a faster more powerful response from
the motor drive combination.

Dave Caroline

On 05/05/2015, Tom Easterday <[email protected]> wrote:
> Thanks, I'll give it a try tomorrow.  I did see in the Vexta manual that it
> be connected as you suggest so I am hoping this is my problem and not a bad
> motor or drive as Jon alluded to (Thanks as well, Jon).
> -Tom
>
>> On May 4, 2015, at 8:41 PM, Peter C. Wallace <[email protected]> wrote:
>>
>> Just to make sure its not a current drive issue, can you try connecting
>> the step and dir signals to the 7I85S such that the 7I85S sinks current to
>> drive the OPTO? The current batch of 7I85S's sink current better than
>> source so you would connect the OPTO + to 5V and OPTO- to 7I85S output to
>> get maximum drive
>
> ------------------------------------------------------------------------------
> One dashboard for servers and applications across Physical-Virtual-Cloud
> Widest out-of-the-box monitoring support with 50+ applications
> Performance metrics, stats and reports that give you Actionable Insights
> Deep dive visibility with transaction tracing using APM Insight.
> http://ad.doubleclick.net/ddm/clk/290420510;117567292;y
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
>

------------------------------------------------------------------------------
One dashboard for servers and applications across Physical-Virtual-Cloud 
Widest out-of-the-box monitoring support with 50+ applications
Performance metrics, stats and reports that give you Actionable Insights
Deep dive visibility with transaction tracing using APM Insight.
http://ad.doubleclick.net/ddm/clk/290420510;117567292;y
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to