On Wed, 27 May 2015, andy pugh wrote: > On 27 May 2015 at 15:23, <[email protected]> wrote: > >> Before I screw up can you offer wiring suggestions > > The 4th picture shows how to wire it up for PWM control. > > When you connect the mains supply, does 5V appear on the pin shown in > orange in that picture?
No, I get about 0.25 volts > (I can't decide if that is a 5V input or output). > > If it is an input then that's fairly easy, you connect that to BoB 5V > and take the black PWM wire to a parallel port pin (or other sinking > output). > > it seems to be a DC motor, so only two wires go to the spindle. > > -- > atp > If you can't fix it, you don't own it. > http://www.ifixit.com/Manifesto > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
