Best is to use an enable signal on the controller when it has one. Next best is to turn the controller on and off. Worst is putting anything between the controller and the motor. On some motors and controllers disconnecting the motor from the controller under load can damage the controller.
-- Ralph ________________________________________ From: [email protected] [[email protected]] Sent: Tuesday, June 02, 2015 11:25 AM To: [email protected] Subject: Re: [Emc-users] spindle for table top mill One more time, in reference to this dc spindle motor http://www.ebay.com/itm/201280571303?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT When power is applied to the controller the motor starts running Is it ok to switch the controller off/on or better to put a relay between the motor and the controller ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
