On 28 May 2015 at 13:26, Marius Liebenberg <mar...@mastercut.co.za> wrote:
> Should I use any other than Tx M6 with G43 already active in the setup > code? Yes. G43 is not modal. You need to G43 after every tool change. (Actually, it is possible to configure for "sticky" G43, but I think that was an experimental addition) In practice touching-off Z to the chuck is often less useful that setting zero as the end just faced-off and working negatively. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
