The error would help a lot... on my plasma machine I have a "Rapid to Home" button and after I'm done cutting and before shutting off I press the magic button. Homing only takes a few seconds when I fire it back up.
JT On 6/25/2015 8:33 PM, Eric H. Johnson wrote: > Hi all, > > > > I am not sure I understand why I cannot increase my home velocity for X and > Y. I have a 12' by 20' table and have not been able to increase the home > velocity much above 0.25, which is tortuously slow (linuxcnc 2.6). > Unfortunately I did not write down the exact error message when I was at the > machine, but looking it up it seemed to indicate that the home sensor did > not stay stable long enough to complete the home. > > > > My home sensors are micro-switches which are closed by a plate which first > contacts the home sensor, then the end of travel limit, and finally the hard > stop. Once contact is made, the switches never release until the axis > reverses direction. The home sensors are debounced, and I increased the > debounce time from about 5ms to 10ms, so I am pretty sure there is not a > state change once the debounce time is satisfied on initial contact. > > > > Is there something about the homing sequence I am still missing? > > > > Thanks, > > Eric > > > <http://t.sidekickopen07.com/e1t/o/5/f18dQhb0S7ks8dDMPbW2n0x6l2B9gXrN7sKj6v4 > LCQRN7fcnk8RJ6s6N8rBF7Rd3_yKW18Chwm1k1H6H0?si=6453247850577920&pi=90ee8c53-8 > 5e5-4df5-b55c-48515242dba9> > ------------------------------------------------------------------------------ > Monitor 25 network devices or servers for free with OpManager! > OpManager is web-based network management software that monitors > network devices and physical & virtual servers, alerts via email & sms > for fault. Monitor 25 devices for free with no restriction. Download now > http://ad.doubleclick.net/ddm/clk/292181274;119417398;o > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Monitor 25 network devices or servers for free with OpManager! OpManager is web-based network management software that monitors network devices and physical & virtual servers, alerts via email & sms for fault. Monitor 25 devices for free with no restriction. Download now http://ad.doubleclick.net/ddm/clk/292181274;119417398;o _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
