Yes I know and I love it. Just cannot make it work on my lathe when I have NGCGUI installed on Gmoccapy. None of the macros or MDI calls run and there seem to be no solution at hand :( On an older installation the macros work but on the lastest stuff not.
------ Original Message ------ From: "andy pugh" <[email protected]> To: "Marius Liebenberg" <[email protected]>; "Enhanced Machine Controller (EMC)" <[email protected]> Sent: 2015-06-28 23:28:31 Subject: Re: [Emc-users] Threading wizard problems >On 23 June 2015 at 17:56, Marius Liebenberg <[email protected]> >wrote: >> This wizard of Bob's does a lot of things such as grooving, >>threading, >> radius and curves and a lot more. Well worth the couple of bucks. > >For a couple of bucks less... >http://www.linuxcnc.org/index.php/english/forum/41-guis/26550-lathe-macros > > >-- >atp >If you can't fix it, you don't own it. >http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Monitor 25 network devices or servers for free with OpManager! OpManager is web-based network management software that monitors network devices and physical & virtual servers, alerts via email & sms for fault. Monitor 25 devices for free with no restriction. Download now http://ad.doubleclick.net/ddm/clk/292181274;119417398;o _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
