Greetings, I am trying to add a 4th axis to my USC from Pico Systems. My set of config files is at:
<http://3DTOPO.com/pico-univstep.tar.gz> I defined the new axis as W and set it up the way the other axes are setup as far as I can tell. I didn’t set up the limit switches because I wasn’t sure what pins to use. Anyhow, I can’t get Axis to launch with the W enabled. I get the error: Can not find -sec APPLICATIONS -var DELAY -num 1 HAL: ERROR: duplicate component name 'inihal' ini_hal_init: ERROR: hal_init() failed HAL: ERROR: duplicate component name 'inihal' ini_hal_init: ERROR: hal_init() failed HAL: ERROR: duplicate component name 'inihal' ini_hal_init: ERROR: hal_init() failed HAL: ERROR: duplicate component name 'inihal' ini_hal_init: ERROR: hal_init() failed HAL: ERROR: duplicate component name 'inihal' ini_hal_init: ERROR: hal_init() failed A configuration error is preventing LinuxCNC from starting. More information may be available when running from a terminal. I grepped around for ‘inihal’ but find no such term in my configs. Full error log is here: <http://3DTOPO.com/wAxisErr.txt.gz> BTW: I assume the 5V pin on the stepper drive goes to the 5V on the USC, but where does the enable go (been a while!)? Thanks, Jeshua Lacock Founder/Engineer 3DTOPO Incorporated <http://3DTOPO.com> Phone: 208.462.4171 ------------------------------------------------------------------------------ Monitor Your Dynamic Infrastructure at Any Scale With Datadog! Get real-time metrics from all of your servers, apps and tools in one place. SourceForge users - Click here to start your Free Trial of Datadog now! http://pubads.g.doubleclick.net/gampad/clk?id=241902991&iu=/4140 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
