I wonder if a 2 pole would be overkill for a probe cable? JT
On 12/26/2015 3:35 PM, andy pugh wrote: > On 26 December 2015 at 04:28, Jack Coats <[email protected]> wrote: > >> I am contemplating either direct wiring (just solder, tape, heat >> shrink tube) each wire back to the screw terminals on the stepper >> driver. > Direct wire is cheaper and more reliable. But you can almost guarantee > that if you make permanent connections then you will need to > disconnect them. > >> Second option is using connectors, DIN (screw attach cover) or Molex >> push connectors near the stepper, > Connectors cost more money (sometimes an awful lot of money). But you > can almost guarantee that if you use connectors then you will never > need to disconnect them. > > For motors I have started to use the Neutrik 4-pole speaker > connectors. They are not very expensive, they have a nice feel of > quality (much more than DIN) and are rated at 20A or 40A. > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
